TV LED STRIP INSTALLATION GUIDE
NEVER TURN ON THE LIGHTS WHILE ROLLED UP. THEY WILL OVERHEAT AND BREAK
Step 1: Clean the backside of the TV using a dry cloth. We recommend placing the TV on a flat and soft surface to make this installation easier.
Step 2: Unroll the LED Strip from its roll
Step 3: Remove the blue plastic liner, to reveal the adhesive. Reveal the adhesive one foot at a time, to avoid debris from getting on the rest of the adhesive.
Step 4: Begin the installation at the bottom left corner of the TV, moving upward from there. Make sure to leave the connector end, hanging off the edge of the TV. Remember to continuously press down using your fingers, on the LED Strip to make the adhesive stick.
Step 5: Create a 90° loop at the corners, then run the LED Strip towards the next corner. Repeat this step until you have gone around the entire TV
Step 6: Go back over and make sure the LED Strip is flat along the entire installation path, while also pressing down on the LED Strip with your fingers to make sure the adhesive is sticking on firmly.
Step 7: Once you reach the starting point, cut off the excess LED Strip at the designated cutting mark. This will be marked by copper lines with a scissor icon.
Step 8: Connect the power supply to the IR receiver (white box connector)
Step 9: Connect the IR receiver to the LED Strip, making sure the arrow at the connectors is aligned.
Step 10. Plug in, and enjoy the show!
QUICK LINKS:
LED Light Strip Installation Guide
Light Strips Falling Down? Best Solutions
TV LED Strip Installation Guide
Fix Remote and LED Strip Colors Not Matching
GET YOUR SETUP STARTED: